qadd next up previous contents
Next: qali Up: Commands Previous: proj   Contents


qadd

   'qadd' <set|seq> RETURN <'w'|'a'|'i'|'r'|'n'|'e'|'f'|'p'|'l'| ->
   's'|'b'|'S'|'L'|'h'|'m'|'q'|'s'|'t'|'u'>
This keyword is used to add entities to a set. See also seta. But a set will not keep the sequence in which the entities were selected. Use seqa or the command ``qseq'' if the order of the selected entities has to be kept.

After an entitiy was selected you get certain informations about the entity. If the node which belongs to the maximum or minimum value in a certain area has to be stored in a set you might use the same key-strokes as described for the command ''qenq''.

To catch more than one entity with one stroke, type ''a'' (all) at first. Then create a rectangular picking area by pressing two times the ''r'' key. Both strokes define opposite corners of the selection-rectangle. To catch only the entity which is closest to the user type ''i'' before.

Then move the mouse pointer over the entity(s) and press one of the following keys, for Nodes n, Elements e, Faces f, Points p, Lines l, Surfaces s, Bodies b, Nurb Surfaces S, node attached texts t and for Nurb Lines L.

Press ''q'' to quit the command.

It is also possible to measure distances between two pixels on the screen. Just press the key ''w'' on the positions of the two pixels. The distance is calculated in the scale of the displayed geometry.


next up previous contents
Next: qali Up: Commands Previous: proj   Contents
root 2012-10-04