Weir Crest next up previous contents
Next: Weir slope Up: Fluid Section Types: Open Previous: Sluice Opening   Contents

Weir Crest

Figure 99: Weir geometry
\begin{figure}\epsfig{file=Weir.eps,width=10cm}\end{figure}

The weir crest is the upstream element of a pair of boundary elements simulating a weir. The corresponding downstream element is the weir slope. Both are illustrated in Figure 99. The weir can occur in different forms such as broad-crested weirs (left picture in the Figure) and sharp-crested weirs (right picture in the Figure). The volumetric flow $ Q$ can be characterized by a law of the form

$\displaystyle Q=C b (h-p)^{3/2},$ (42)

where C is a constant. For instance, in the formula by Poleni $ C=2 C_d \sqrt{2
g}/3$, where $ C_d$ is coefficient smaller than 1 to be measured experimentally [11]. The following constants have to be specified on the line beneath the *FLUID SECTION,TYPE=CHANNEL WEIR CREST card:

The cross section of the weir is supposed to be rectangular. This is important, since a different form leads to a different exponent in Equation 42. Notice that a weir can have upstream channel elements attached to it. In that case it is mandatory to specify an upstream reference element.


Example files: channel7.


next up previous contents
Next: Weir slope Up: Fluid Section Types: Open Previous: Sluice Opening   Contents
guido dhondt 2012-10-06