Restrictor, Entrance next up previous contents
Next: Restrictor, Exit Up: Fluid Section Types: Gases Previous: Restrictor, Wall Orifice   Contents

Restrictor, Entrance

An entrance element is used to model the entry from a large chamber into a gas pipe. For an entrance the value of $ \zeta$ is 0.5. It is described by the following constants (to be specified in that order on the line beneath the *FLUID SECTION, TYPE=RESTRICTOR ENTRANCE card):

By specifying the parameter LIQUID on the *FLUID SECTION card the loss is calculated for liquids. In the absence of this parameter, compressible losses are calculated.



guido dhondt 2012-10-06