Inhomogeneous Conditions next up previous contents
Next: Submodel Up: *BOUNDARY Previous: Homogeneous Conditions   Contents

Inhomogeneous Conditions

Inhomogeneous conditions can be defined between a *STEP card and an *END STEP card only.


First line:

Following line:

Repeat this line if needed.

Example:

*BOUNDARY
Nall,2,2,.1

assigns to degree of freedom two of all nodes belonging to node set Nall the value 0.1.

Example:

*BOUNDARY,MASS FLOW
73,1,1,31.7

applies a mass flow rate of 31.7 to node 73. To have any effect, this node must be the midside node of a network element.


Example files: achteld.



guido dhondt 2012-10-06